Antunes VCT-35 - OPERATION; Operating Instructions; Safety Features Explained

VERTICAL CONTACT TOASTER
8
P/N 1011287 Rev. E 02/18
Operating Instructions
1. Set the Bun Thickness Adjustment Control knobs
to the desired settings (Figure 6). The recom-
mended setting is 6.
NOTE: After initial run of 4-6 buns, adjust controls
according to the desired finished product.
2. Turn the Rocker Switch (power On/Off) to ON
(Figure 5).
3. Turn the Temperature Control to 10. Allow 30
minutes warm-up time before proceeding.
4. Drop buns into toaster with the cut sides of heel
and crown facing each other (Figure 5).
5. Toasted product will drop into the Bun Landing
Area (Figure 5).
6. Test at least 4 buns before putting toaster into
service. Turn the Temperature Control to a lower
setting for lighter toasting or to a higher setting for
darker toasting.
7 Turn the unit off when finished toasting
Safety Features
HI-LIMIT RESET BUTTON
A hi-limit thermostat will turn off electrical power to the
heater and control circuits if the unit overheats. To
reset this thermostat, allow sufficient time (10-15 min-
utes) for the unit to cool down, then press and release
reset button located at the rear of the unit (Figure 5).
If the unit requires continuous resetting, contact your
Maintenance Person or Antunes Technical Service.
CONVEYOR INTERLOCK SAFETY SWITCH
A Conveyor Interlock Safety Switch (some models) is
located on top of the unit under the Heat Shield (Figure
4). The conveyors will not rotate unless the Heat
Shield is properly in place and activating the Conveyor
Interlock Safety Switch.
NOTE: As of March 2017, the Interlock Switch was
removed from use. If your toaster has the Interlock
Switch, you will need to place the Heat Shield onto
the toaster in order for the conveyors to turn. If
your toaster does not have an Interlock Switch, the
conveyors will turn as long as the unit is on.
OPERATION
1
2
3
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
4 = 3/4"(19.1mm)
5 =13/16"(20.6mm)
6 = 7/8"(22.2mm)
THICKNESS
THICKNESS
1
2
3
4
5
6
6
3 =11/16"(17.5mm)
Figure 6. Bun Thickness Adjustment Controls
1
2
3
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
4 = 3/4"(19.1mm)
5 =13/16"(20.6mm)
6 = 7/8"(22.2mm)
THICKNESS
THICKNESS
1
2
3
4
5
6
6
3 =11/16"(17.5mm)
Figure 5. Toaster Controls
Bun Thickness
Adjustment Controls
Bun Landing
Area
Rocker Switch
Hi-Limit Reset
Temperature Control
(see Figure 6)