Anybus Wireless Bolt

AT Commands 13 (88)
3.3.7 AT*BSP Server Profile
AT*BSP=
Sets the Bluetooth server profile. A reboot is needed for the setting to take effect. Please note
that following values will be affected depending on what role is selected: NAP: AT*BMSP
Master Slave policy will be set to 0, ATS2010 max number of connections will be set to 7,
AT*BCM Connectability mode will be set to 2. PANU: AT*BMSP Master Slave policy will be set
to 1, ATS2010 max number of connections will be set to 1, AT*BCM Connectability mode will be
set to 1. IMPORTANT: As the device is connectable after NAP has been set an appropriate
Security Mode should be configured.
Syntax:
AT*BSP=<server_profile>
Input Parameters:
Name
Type Description
server_profile Integer The role of the device:
100: PAN User role, PAN Profile
101: Network Access Point role, PAN Profile.
Requires a reboot for the changes to take effect.
Example:
Input: AT*BSP=101 sets the device to the Network Access Point role.
AT*BSP?
Gets the Bluetooth server profile.
Syntax:
AT*BSP?
Example:
Input: AT*BSP? returns the server profile. See AT*BSP= for values.
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7