Anybus Wireless Bolt - Model Name - Certification Identifier

AT Commands 6 (88)
3.2 Network Commands
3.2.1 AT*ANDHCP DHCP Mode
Set/get the DHCP mode. If activated, this will take precedence over settings made with
AT*ANIP. For default value see AT*AMDEFAULT.
AT*ANDHCP=
Set the DHCP mode
Syntax:
AT*ANDHCP=<dhcp_client>,<dhcp_server>,<store>
Input Parameters:
Name
Type Description
dhcp_client Integer 0: Off, use static IP address
1: On, acquire an IP address using DHCP
dhcp_server Integer 0: Off, Disable DHCP server
1: ON, Enable DHCP server
2: DHCP Relay, Relay DHCP messages to an external DHCP server.
store Boolean If store is 1 the new value is stored permanently.
Requires a reboot for the changes to take effect.
AT*ANDHCP?
Read the current DHCP setting
Syntax:
AT*ANDHCP?
Example:
AT*ANDHCP?<br>*ANDHCP:<dhcp_client>,<dhcp_server>
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7