Anybus Wireless Bolt - WLAN Client (STA) Commands

AT Commands 38 (88)
3.6 WLAN Client (STA) Commands
3.6.1 AT*WSMAC WLAN MAC address
Can be used to clone a MAC address from an Ethernet device. This will allow layer 2 data to be
bridged by one device. Can be combined with IP forwarding.
AT*WSMAC=
Set the WLAN MAC address. If set to all 0 or all FF the unit's default address will be used.
Syntax:
AT*WSMAC=<mac>
Input Parameters:
Name
Type Description
mac
MACAddress The MAC address to set.
Requires a reboot for the changes to take effect.
AT*WSMAC?
Get the MAC address.
Syntax:
AT*WSMAC?
Example:
AT*WSMAC?<br>*WSMAC:<mac>
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7