To Next Page

To Previous Page

AT Commands 39 (88)

3.6.2 AT*WSBM WLAN Bridge Mode

AT*WSBM=

Set the WLAN Bridge Mode. In layer 2 tunnel mode all layer 2 data will be bridged over WLAN.

Please note that this option uses a custom protocol and can only be used when the AP and the

remote device are of the same type Layer 2 cloned MAC only mode is used in combination with

AT*WSMAC. In this mode only data from the cloned MAC will be bridged over WLAN. When

using MAC clone two devices will use the same MAC - hence there is no way for a DHCP

server to distinguish them from one another and both devices will receive the same IP address.

In layer 3 IP forward mode IP data from all data will be bridged over WLAN. Please note that

this mode can be combined with AT*WSMAC to enable layer 2 data for one device. For default

value see AT*AMDEFAULT.

Syntax:

AT*WSBM=<mode>

Input Parameters:

Name

Type Description

mode Integer The Bridge Mode to set.

0: Layer 2 tunnel

1: Layer 2 cloned MAC only

2: Layer 3 IP forward

Requires a reboot for the changes to take effect.

AT*WSBM?

Get the Bridge Mode.

Syntax:

AT*WSBM?

Example:

AT*WSBM?<br>*WSBM:<mode>

3.6.3 AT*WSC Connect

AT*WSC

Connect to Access Points as specified in the Connection List.

Syntax:

AT*WSC

Example:

Input: AT*WSC returns OK if the connection succeeds, ERROR otherwise.

Wireless Bolt

™

/ Wireless Bridge II

™

Reference Guide SCM-1202-004 EN 1.7

Anybus Wireless Bolt Reference Guide

Other manuals for Anybus Wireless Bolt