AT Commands 5 (88)
3 AT Commands
3.1 Standard Commands
3.1.1 AT&F Restore to Factory Settings
AT&F
This command instructs the unit to set all parameters to their defaults as specified by the
manufacturer.
Syntax:
AT&F
3.1.2 AT* List Available Commands
Returns a list of all available AT commands
AT*
Syntax:
AT*
Example:
Input: AT*<br>Output:<br>AT&F<br>AT*<br>AT<br>AT*ANDHCP?<br>AT*ANDHCP=
<br>AT*ANIP?<br>AT*ANIP=<br>AT*ANHN?<br>AT*ANHN=<br>AT*BCP=<br>...
<br>
3.1.3 AT Attention
AT
Attention command determining the presence of a DCE
Syntax:
AT
Wireless Bolt
™
/ Wireless Bridge II
™
Reference Guide SCM-1202-004 EN 1.7
To Next Page
Loading...
Need help?
General
