Anybus Wireless Bolt Startup Guide

Special Conditions of Use:
• The equipment shall only be used in an area of at least pollution degree 2, as defined in IEC 60664-1.
• The equipment shall be installed in an enclosure that provides a minimum ingress protection of IP 54 in
accordance with EN 60079-15.
• Transient protection shall be provided that is set at a level not exceeding 140 % of the peak rated
voltage value at the supply terminals to the equipment.
Warnings
• WARNING - EXPLOSION HAZARD - SUBSTITUTION OF ANY COMPONENTS MAY IMPAIR
SUITABILITY FOR THE EXPLOSIVE ENVIRONMENT
• WARNING - EXPLOSION HAZARD - WHEN IN HAZARDOUS LOCATIONS, TURN OFF POWER
BEFORE REPLACING OR WIRING MODULES.
• WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT WHILE THE CIRCUIT IS
LIVE OR UNLESS THE AREA IS KNOWN TO BE FREE OF IGNITABLE CONCENTRATIONS.
• WARNING - EXPLOSION HAZARD - INSTALL ON AN ENCLOSURE CONSIDERED
REPRESENTATIVE OF THE INTENDED USE. TO COMPLY WITH ATEX DIRECTIVES, THE
EQUIPMENT MUST BE MOUNTED ON AN IP54 ENCLOSURE.
© 2018 HMS Industrial Networks AB SCM-1202-063 EN 1.2 / 2018-05-18 / 8674
Anybus
®
Wireless Bolt
™
Compliance Sheet 2 (2)

Anybus Wireless Bolt Specifications

General

Brand	Anybus
Model	Wireless Bolt
Category	Network Hardware
Language	English