9 | ANYLOAD NPS Series Pallet Jack Scale Operator’s Guide (V1906) – T15E v2 series indicator
2. If zero correction or zero calibration is needed, enter [ 0000.0] as the
calibration weight then proceed the calibration. It will return to
weighing mode.
6. Power Supply
POWER SELECTION
1. 7.4V/2500mAh Lithium Rechargeable battery
2. 110 - 220V AC/DC adaptor 10VDC, 1000mA
Instructions for using the battery:
1. Fully charged the battery during its first time use
Use the specified charger/ power adaptor and plug it to a source
ranging 100-240VAC, 50/60hz. The battery is being charged when the
display is showing “ CHArGE” “ -------“ and “ Pbtxx”
2. When the low battery symbol is on, it means the power of scale is low
and needs to change the battery or to recharge using the specified
adaptor.
To Next Page
Loading...
