32
Extra
Exit Enter Select
Extra
LEA
AutoInput Select
Resolution: 3840(H)x2160(V) SDR
H.Frequency: 135 KHz
V.Frequency: 60 Hz
Orbit Off
Off
USB Off
USB Selection Auto
Exit Enter Select
Extra
OffOff RS
Resolution: 3840(H)x2160(V) SDR
H.Frequency: 135 KHz
V.Frequency: 60 Hz
Off Timer
Image Ratio
0
Wide
DDC/CI
Yes
Exit Enter Select
Extra
NoReset
Resolution: 3840(H)x2160(V) SDR
H.Frequency: 135 KHz
V.Frequency: 60 Hz
Working Time
Time after Off-RS
1.3
1.3
Off-RS Counts
0
JB Counts
0
Input Select
Auto/ HDMI1/HDMI2 /DP/
USB C* /Miracast/AirPlay/
DLNA
Select Input Signal Source
USB
Off/ High Resolution/High
Data Speed
For model need to turn on/o USB power during
power saving
.
The default USB setting is O. If you want to
connect USB-C device, please adjust the USB
setting to
High Resolution
or
High Data Speed
.
USB Selection Auto / USB C / USB up Select the USB upstream data path.
LEA
(Prevention
of local image
retention)
On/ Off
It is used to turn on the LEA function to reduce the
risk of generating image retention. Recommended
function settings: “On.”
After this function is enabled, the screen will be
automatically narrowed to fix the brightness of
the display area, so as to reduce possible image
retention.
Orbit
(Image shift)
O / Weak /
Medium /Strong / Strongest
It is used to turn the Orbit function on to reduce the
risk of generating image retention. Recommended
function setting: “On.”
After this function is enabled, image pixels will
circularly move as a whole. The movement
amplitude is based on the settings. The moved
character may be side cut. When “Strongest”
is selected, image retention is most unlikely
generated, but possible side cut may be most
notable.
Off-RS
(Elimination
of image
retention)
On/ Off
It is used to enable and run the OFF-RS function
to eliminate image retention which has been
generated.
After startup, select “Yes” according to menu
prompts, and then the display will automatically
shut down the screen. Keep power on, and do not
operate any keys. The power indicator will flash
white (white a second/o a second). This process
lasts for about 10 min. The power indicator turns o
at the end, and the display enters standby state.
To Next Page
Loading...
Need help?
General
