29
The description for function control LEDS
1. CONTRAST Adjust the picture contrast.
2. BRIGHTNESS Adjust the picture brightness.
3. H-SIZE Adjust the picture’s horizontal size.
4. H-CENTER Adjust the horizontal position of the picture.
5. V-SIZE Adjust the picture’s vertical size.
6. V-CENTER Adjust the vertical position of the picture.
7. PINCUSHION Adjust the pincushion and barrel.
8. TRAPEZOID Adjust the picture’s trapezoid distortion.
9.
+
RECALL To recall original factory preset mode.
The power management feature of this product complies with every power
saving requirements of ENERGY STAR
and VESA DPMS when activated, it
automatically reduces unnecessary power consumption of the monitor
when your computer is not in use.
To use the feature, the monitor needs to be connected to a VESA DPMS
computer. There are three power management modes available, these are
described below. The required settings, including the timer setting, should
be made by the computer.
•
Stand-by Mode
When the H-sync signal from the computer is off, the monitor enters into
Stand-by Mode which reduces the power consumption to less than 15W.
The screen becomes dark, and the power indicator turns to orange. From
Stand-by Mode, the screen reappears instantaneously when the
keyboard or the mouse is touched again.
ADJUSTING THE PICTURE
POWER MANAGEMENT FEATURE
To Next Page
Loading...
Need help?
General
