- 9 -
In Standby Mode, press button to enter Menus, and go to SETUP, find “IR CUT” in .
1) Manual : Long press to turn on/off Infrared Light.
2) Auto : At night or in the dark, when photoresistor senses the low-light environment, Infrared
Light will be turned on/off automatically.
Short press to turn on the red dot laser,press again to turn off.
Caution:
Laser Point
This device generates a visible red light that is moderately hazardous and should not be
viewed by the naked eye on the same axis as the beam.
To Next Page
Loading...