AOR AR1000 - Memory Operation; Entering Frequency to Memory; Entering New Frequency;Mode to Memory; Recalling Memory Contents

1. To enter a frequency into memory from display.
PROG - (memory bank and channel) - ENTER
Example. Enter frequency on display into memory bank 1, channel 52.
~OG - 152 - ENTER
2. To enter a new frequency and mode into memory.
MANUAL - (frequency in MHz) - ENTER - (mode) - PROG -
(memory bank and channel number)
Example: Enter 144.025 MHz, FM mode, into memory bank 0 channel 55.
AfANUAL - 144.025 - ENTER - FM - PROG - 055
5. To recall the contents of any memory.
MANUAL - BANK - (bank and channel number)
Example: Recall contents of bank 3 channel 26.
MANUAL - BANK - 326
4. To clear a memory.
MANUAL - CLEAR - ENTER - PROG - (bank and channel number)
Example: Clear contents of bank 1 channel 20.
MANUAL - CLEAR - ENTER - PROG - 120
Scannins Operation
1. Scan all memories
PRESS SCAN. (having set SQUELCH control to cut off background noise)
2. Start scan at a particular bank
SCAN - BANK - (bank number)
3. Programmed bank scan
SCAN - BANK - PROG - (start bank number ) - LIMIT - (end bank number)
4 ENTER
~xam~le\ To scan between bank 1 and bank 5.
SCAN - BANK - PROG - 1 LIMIT - 5 - ENTER
4. Memory channel lockout
MANUAL - BANK - (bank and ahannel number) - LOCKOUT
(.lockout confirmed by flashing 'IL.OUTl1 in display. )
Page 4