APART CONCEPT1 - Technical Specifications

WWW.APART-AUDIO.COM
10
CONCEPT1 & CONCEPT1T TEChNiCal sPECifiCaTiONs
concept 1
DynamicS program power, both channelS DriVen, 8 ohm 50 w + 50 w
DynamicS program power, both channelS DriVen, 4 ohm 80 w + 80 w
DynamicS capacity at 1,7 ohm DipS / ch 120 w
note ; power output controlleD by Digital limiter
lo-cut filter 75 hz / 12 Db/oct
Speaker impeDance - connection 4 - 16 ohmS / ch - euroblock SecureD Screw terminalS
Digital control
rS232 Sub-D9, galVanically iSolateD
ir (ir-remote control optional) front ir eye, rear mini-jack
inputS / outputS
Source inputS a-b-c-D input impeDance / SenSitiVity 15 kohm / 0,3V -10DbV, maX 2,7V +8,5DbV
Source inputS a-b-c-D Digital preSet gain range -20 / +14 Db
Source Digital tone control baSS 90hz, treble 15 khz, +/- 14Db
automatic louDneSS +6Db (90hz) / +4Db (15 khz) to flat 0Db
micro balanceD input impeDance / SenSitiVity 1,5 kohm / 1,5 mV -56DbV, maX 0,4V -8DbV
micro balanceD input rear panel gain trim -56 / -16 DbV mic - line
micro tone control ; rear panel lo - hi 100hz/+3Db,10khz/-6Db to 100hz/-9Db, 10khz/+4Db
pre-out impeDance / SenSitiVity 1 k ohm / 0 DbV
line-out impeDance / SenSitiVity 1 k ohm / +3 DbV
general
operation moDeS Stereo / 2 zoneS linkeD / 2 inDiViDual zoneS
micro paging 1 or 2 zone
frequency reSponSe (- 0,5 Db) 10hz-40 khz
thD < 0,05%
Technical Specifications