5
2.0 Safety! ENGLISH
Caution!
CAUTION!
■ To reduce the risk of electric shock, disconnect the Uninterruptible
Power Source from the mains before installing computer interface signal
cable (when used). Reconnect the power cord only after all signalling
interconnections have been made.
■ Connect the Uninterruptible Power Source to a two-pole, three-wire
grounding mains receptacle. The receptacle must be connected to
appropriate branch protection (fuse or circuit breaker). Connection to any
other type of receptacle may result in a shock hazard and may violate local
electrical codes.
■ This Uninterruptible Power Source has an internal energy source
(the battery) that cannot be de-energized by the user. The output may be
energized when the unit is not connected to a mains supply.
■ To properly deenergize the Uninterruptible Power Source in an
emergency, move the rear panel I/O switch to the O (off) position and
disconnect the power cord from the mains.
■ Avoid installing the Uninterruptible Power Source in locations where
there is water or excessive humidity.
■ Do not allow water or any foreign object to get inside the
Uninterruptible Power Source. Do not put objects containing liquid on or
near the unit.
■ To reduce the risk of overheating the Uninterruptible Power Source,
avoid exposing the unit to the direct rays of the sun. Avoid installing the
unit near heat emitting appliances such as a room heater or stove.
To Next Page
Loading...
Need help?
General
