Fig
4-4 Input Wiring Pathway
8. Connect input wires to the input terminal block connec-
tions labeled L1 and N as shown in figure 4-5. Make sure
there are no loose strands and that the terminal connection
screws are sufficiently tightened.
Fig 4-5 Input Hardwiring Connections
9. Carefully fold the excess wiring into the entry compart-
ment. After the electrical wiring test/checklist at the end of
this chapter is completed, replace the input wiring panels.
Fig 4-2 Ground Wiring and Input Wiring Terminal Blocks
6. Connect the ground wire to the ground wiring terminal
block. See figure 4-3. Make sure there are no loose strands
and the terminal connection screw is sufficiently tightened.
Fig 4-3 Ground Hardwiring Connection
7. Feed the L1 and Neutral wires through the wiring pathway
hole to the input wiring terminal block. See figure 4-4 for
the input wiring pathway.
Chapter 4 - Electrical Requirements and Procedures
4-3
Input Ground Wire
Neutral Wire
L1 Wire
Existing Wiring
Ground Wiring Terminal Block
Input Wiring Terminal Block
Existing Wiring
To Next Page
Loading...