To Next Page

To Previous Page

Regulator Owner’s Manual

............................................................................................

CAUTION! Ensure location

grooves are free from dirt and

debris.

3. Refitting the exhaust diffusers

is carried out by sliding ONE

diffuser at a time onto the

case, once both diffusers are

located on the case, squeeze

the two diffusers together until

you hear an audible “click”.

NOTE: The removal and

refitting of the small exhaust

diffusers is carried out in

exactly the same way as the large exhaust diffusers. If the exhaust

diffusers do not securely clip together then they may become

detached and lost. (If required, exhaust diffusers may be purchased

separately).

WARNING: Do not attempt to use tools to remove or attach the

exhaust diffusers. After the removal of the exhaust diffusers, care

must be taken to prevent damage to the exhaust valve. Do not

attempt to poke, pull or touch the exhaust valve or surrounding

area with any tools. If damage to this part or surrounding area

occurs then this could cause your regulator to leak, causing

serious malfunction or even personal injury. Care must be

taken when securing alternative sets of diffusers, do not apply

excessive force as damage may occur to the diffusers, exhaust

valve or surrounding area.

Shaded area

indicates

exhaust

valve and

surrounding

area.

Showing

Compact

Exhaust Option

LOCATE

SLIDE

Apeks DST Owner's Manual

Other manuals for Apeks DST