TABLE 5: RECOMMENDED CLEANERS AND LUBRICANTS
LUBRICANT/CLEANER APPLICATION SOURCE
Christo-Lube MCG 111
All o-rings
Aqua Lung, PN 820466, or
Lubrication Technologies
310 Morton Street
Jackson, OH 45640
(800) 477-8704
Oakite #31
Acid bath for reusable stainless
steel and brass parts.
Oakite Products, Inc.
50 Valley Road
Berkeley Heights, NJ 07922
White distilled vinegar
Acid bath for reusable stainless steel
and brass parts.
“Household” grade
Liquid dishwashing detergent
(diluted with warm water)
Degreaser for brass and stain-
less steel parts; general cleaning
solution for plastic and rubber.
“Household” grade
CAUTION: Silicone rubber requires no lubrication or preservative treatment.
DO NOT apply grease or spray to silicone rubber parts. Doing so may cause a
chemical breakdown and premature deterioration of the material.
CAUTION: Do not use muriatic acid for the cleaning of any parts. Even if
strongly diluted, muriatic acid can harm chrome plating and may leave a
residue that is harmful to o-ring seals and other parts.
PART # DESCRIPTION / KEY ITEM # TORQUE
AP1407
AP1471
Yoke Connector (32)
DIN Handwheel Connector (34)
14.7 ft-lbs (20 Nm)
AP1486
Turret Retaining Bolt (15) 70 in-lbs (8 Nm)
AP0203
AP1408
AP1487
AP1413
MP Hose
Blanking Plugs (9, 18, 19)
40 in-lbs (4.5 Nm)
TEST CONDITION SPECIFICATION
Leak Test Inlet 3000 psig (206 bar) No leaks allowed
MP Inlet 3000 psig (206 bar) 130 - 145 psi (9-10 bar)
MP Creep Inlet 3000 psig (206 bar)
5 psi (0.25 bar) max for 15 seconds
after cycling (purging) regulator
TABLE 3: TORQUE SPECIFICATIONS
TABLE 4: TEST BENCH SPECIFICATIONS
16
To Next Page
Loading...
Need help?
General
