Official Support: kt.support@apemans.com
Screensaver: OFF / 1 Minute / 3 Minutes
Note: If the Screensaver is set to 1 or 3 Minutes, the screen will go
black if there is no manual operation for 1 or 3 minutes. As long as the
REC Light is flashing, the camera is still recording.
License Plate
This is where you input your license plate number.
Format
This is where you can format your microSD card on the Dash Cam.
Default Settings
This set of settings is our recommended setting. We strongly
recommend that you use the default settings. The
default/recommended settings are:
Loop Recording: 3 Minutes
Gravity Sensor: Low
Parking Guard: OFF
Motion Detection: OFF
The Parking Guard and Motion Detection functions should be turned
off while driving, because they are used for parking monitoring.
Version
When you have firmware/software upgrade related queries, it would
be helpful to provide us with this version number.
B. How to Start Recording
If the Dash Cam has been successfully installed in the car, it will
automatically turn on and start recording when the engine starts (for
most cars on the market).
If your Dash Cam does not automatically start and start recording
when the engine starts (this usually depends on your car model),
To Next Page
Loading...
