Apex Digital XT Fit - Check Value; Turn off the Device; Flowchart of Menu settings

10
English
English
(8) Check Value (c XXX)
Press "MENU" button to select [c XXX] menu, which displays a check value. Your home
care provider may ask for this information.
(9) Turn off the Device
Remove the power cord from the electrical outlet, and disconnect power cord from the
power socket on the back of device.
4.4 Flowchart of Menu settings
Enter the user's menu mode by pressing the “MENU” button.
In each setting, when the preferred value has been selected, press "MENU" for confirmation and
press "MENU" again to enter next selection.
NOTE: For physicians, please refer to a separated “Physician’s Additional Instruction”
page.
NOTE:
Once the setting is confirmed, press “MENU” button. Otherwise, the device will
automatically go back to standby without saving the modification if no action is
taken in 20 seconds.
Ramp
(Ramp Time)
P
(Therapy Pressure)
Alt.
(Altitude Compensation)
TM
(Total Meter)
< 0, 5, 10, 15, ……………., 45> min
< 4, 4.5, 5, 5.5, ……………., 20> cmH2O
< 1, 2, 3, 4, 5, 6, 7, 8> if P set at 4-18 cmH2O
< XXXX.X > hr
< 1, 2, 3, 4, 5> if P set at 18.5-20 cmH2O
Ramp P
(Ramp Starting Pressure)
< 3, 3.5, 4, 4.5, ……………., 19> cmH2O
CM
(Compliance Meter)
CM 4 hr
(Session Counter)
c
(Check Value)
< XXXX.X > hr
< XXX >
< XXX >