Apollo Seiko OMEGA - I;O Assignment; Terminal Arrangement of the Connector

15 / 60
12. I/O Assignment
12.1 Terminal Arrangement of the Connector
Signal Name
40 0V 39
38 0V LINE MOVE END 37
36 SEL200 35
34 EXT24V SEL100 33
32 24V AIR BLOW 31
30 24V IRON U/D 29
28 S- 27
26 S+ 25
24 RESET 23
22 AUX OUT STOP 21
20 START 19
18 17
16 SEL64 15
14 IRON UNIT ERROR SEL32 13
12 SOLDER ERROR SEL16 11
10 ACK SEL8 9
8 END SEL4 7
6 RUNNING SEL2 5
4 READY SEL1 3
2 EMR EMR 1
The power source and polarity of I/O can be switched by the switch on the circuit board.
Switch
Number
Contents When ON When OFF
DS1 Switching supply power source
External power
supply
Internal power
supply
DS2
External device output unit
specification (PLC etc.)
NPN PNP
DS3
External device input unit
specification (PLC etc.)
PNP NPN
These switches are on the circuit board
in the left side cover of the controller.
ON⇔OFF
DS3
DS2
DS1
Connector XG4A-4034（OMRON）
 The connection harness should be
provided by end user.