38 / 60
13.9 Cleaning Operation
13.9.1 Soldering Operation by I/O Port
1. Specify a solder condition number by SEL1, SEL2, SEL4, SEL8, SEL16, SEL32,
SEL64, SEL100 and SEL200.
2. Start the soldering operation by START signal.
(Delay of more than 100msec is necessary from solder condition number specification)
3. When it receives START signal, READY signal becomes LOW.
4. When it receives START signal, RUNNING signal becomes High.
5. It starts cleaning.
6. When cleaning is completed, END is outputted as a pulse.
7. When cleaning is completed, READY signal becomes High.
8. When cleaning is completed, RUNNING signal becomes LOW.
* It is not necessary that START signal is outputted as a pulse. (Except for LAN operation)
Cleaning operation is as following.
1. The iron is risen or lowered according to the setting.
2. Air blow is turned on during the setting time.
3. It waits while the setting time after performed air blow.
4. When cleaning setting is set to Down, the iron is risen.
(When cleaning setting is set to Up, the iron remains raised.)
To Next Page
Loading...