37 / 60
13.8.4 Set Temp Operation by Serial Communication Port
It needs to set a suitable WK No. in Solder condition setting in advance.
In Range operation and No Check operation, when “Alarm Temperature Range Low < PV < Alarm
Temperature Range High”, the response of f command returns 0. When except for it, it returns 1.
In Setting Value operation, when PV is judged as the optimal temperature, the response of f
command returns 0. When except for it, it returns 1.
Robot
Board
D Command
f コマンド
SetTemp
Setting Temp. Set
F コマンド
温度判定
Temperature control to
setting temperature
設定温度セット
d Command
H Command
h Command
F Command
Temperature
judging
To Next Page
Loading...