Apollo MX20 User Manual (English)

Other manuals for Apollo MX20

Questions and Answers:

Emily HendrixAug 5, 2025

How to fix a blank screen on my Apollo Monitor?

C
Carrie MarquezAug 5, 2025
If your Apollo Monitor screen is blank, first, check the power wiring to ensure it's correctly connected to the MX20 and that the circuit breaker is closed. Next, verify that the unit isn't in manual intensity control mode with the intensity turned down. If the ambient temperature is below 10°C, allow the unit to preheat for up to 60 seconds. Finally, make sure the data card is fully inserted in the front bezel, flush with the ejector button.

hirwinAug 19, 2025

Why is the INST function not showing on my Apollo MX20?

J
Jimmy WallaceAug 19, 2025
If the INST function isn't showing in install mode on your Apollo Monitor, ensure you're carefully entering the correct installation key sequence after the power-on self-test. Make sure no extra keys are pressed before entering the sequence. If the issue persists, cycle through the available functions by pressing the FN key, as the INST function is on the last available function page.

Screen Size

20 inches

Resolution

1600 x 900

Aspect Ratio

16:9

Panel Type

Brightness

250 cd/m²

Contrast Ratio

1000:1

Response Time

5ms

Input Ports

VGA, DVI

Power Consumption

25W