Solarpaint
AL1206 Installation Manual
14.9.2023
Rev. [B1]
Page 16 of 28
h) For Double sided tape adhesive: remove the protective film from the adhesive.
i) Using 2 workers, hold the module from both short edges. Attach one edge while the opposite
edge is lifted.
j) Advance slowly to the opposite side whilst pressing gently on the adherence lines until
reaching the opposite side.
k) Adhesive types and definitions
1) Corrugated metal sheets
• Single component, silane-modified polymer
• Implementation in "paste" form
• Service temperature of -40 to+90
• Hardness: 45-55 [Shore A]
• Tensile strength: 2.5 -3 [N/mm^2]
• UV resistant
• Application temperature: 5 to 35
2) Corrugated polycarbonate ("Suntuf")
• Single component, Polysiloxane based
• Implementation in "paste" form
• Service temperature of -40 to+100
• Hardness: 15-25 [Shore A]
• Tensile strength: <1.5 [N/mm^2]
• UV resistant
• Application temperature: 5 to 35
3) PVC waterproofing membranes
• Single component, silane-modified polymer
• Implementation in "paste" form
• Service temperature of -40 to+90
To Next Page
Loading...