Continuity Check
• To avoid possible damage to the meter or to the
equipment under test, disconnect circuit power and
discharge all high voltage capacitors before testing
continuity.
CAUTION
!
The continuity check features a buzzer that sounds as
long as a circuit is complete. The buzzer allows you to
quick continuity checks without watching the display.
When measuring resistance is less than threshold, the
buzzer sounds. You can setup the threshold in setup
mode. The continuity threshold is default 30Ω.
To use continuity check, turn the rotary switch to
resistance position, then press the function (yellow)
button to select measuring mode.
501 / 502
EN
To Next Page
Loading...
