Appostar NP-3262 - Page 50

BIOS SETTING
46 NP-3262 POS Terminal
UHCI #1 (ports 0 and 1) / UHCI #2 (ports 2 and 3) / UHCI #3 (ports 4
and 5) /
UHCI #4 (ports 6 and 7)
You can use these items to control USB UHCI (USB 1.1) function, but disable
the controllers from highest to lowest.
Options: Enabled (Default) / Disabled
USB 2.0 (EHCI) Support
You can use this item to enable or disable USB 2.0 (EHCI) Support.
Options: Enabled (Default) / Disabled
SMBus Controller
You can use this item to enable or disable OnChip SMBus Controller.
Options: Enabled (Default) / Disabled
SIRQ Logic
You can use this item to enable or disable SIRQ logic.
Options: Enabled (Default) / Disabled
SIRQ Mode
You can use this item to set SIRQ mode.
Options: Continuous (Default) / Quiet
Onboard PCIE LAN1
This item enables or disables Onboard PCIE LAN1.
Options: Auto (Default) / Disabled / Enabled
Onboard PCIE LAN1 OpROM
This item enables or disables the Boot Option for Legacy Network Devices.
Options: Disabled (Default) / Enabled
DMI Link ASPM Control
This item enables or disables the control of Active State Power Management on
both NB and SB sides of the DMI Link.
Options: Enabled (Default) / Disabled
PCI-Exp. High Priority Port
This item selects a PCI Express High Priority Port.
Options: Disabled (Default) / Port 0 ~ 3
High Precision Timer
This item enables or disables the High Precision Event Timer.
Options: Enabled (Default) / Disabled
SLP_S4 Assertion Width
This item selects a minimum assertion width of the SLP_S4# signal.
Options: 1-2 Seconds (Default) / 2-3 Seconds / 3-4 Seconds / 4-5 Seconds