Programmable Thermostat
Model 8265 Installation and Operation Manual
5/2 Day Programmable Heat Pump Thermostat
PREPARATIONS
Assemble tools required as shown below.
Failure to follow and read all instructions carefully before installing or operating this control could cause personal
injury and/or property damage. If you have any questions, please call Research Products Corporation at (800) 334-6011.
Electric or cordless
drill with 3/16 inch
drill bit, if needed.
Flat blade
screwdriver
Wire cutter/stripper
Level
THERMOSTAT DETAILS
W905 Clip for
Slow Cycle
instead of
Fast Cycle
W904 Clip
for Celsius
instead of
Fahrenheit
W903
Clip to Disable
Progressive Recovery
Feature
Mounting hole
W906 for Emergency Heat
Second Stage Fan Control.
Clip for Fan Control by Equipment
instead of by Thermostat.
O/B
Terminal
Selection
Switch
Mounting
hole
FIGURE 1 – Thermostat Base
To Next Page
Need help?
General
