Aprimatic T22 User Manual

FRANÇAIS
Memory free
signal
Buzzer
Power supply
8
Button 2
Button 1
Button 1
Button 2
Button 3
Button 4
5. REMOTE CONTROL MANAGEMENT (ONLY FOR
T22)
5.1 MEMORY TEST
All the information about the remote controls is saved in
the removable memory module: every time the device with
built-in receiver is turned on, a test is run automatically to
establish which part of the memory is available for the
addition of extra remote controls.
When the device is turned on, after a brief pause during
which the memory is scanned, the buzzer emits a certain number of beeps (from 1 to 10)
to indicate the percentage of the memory which is free: each beep corresponds to
approximately 10% free memory (10 beeps = 100% free memory).
5.2 PROCEDURE FOR TOTAL DELETION OF THE MEMORY
1. Power down the device.
2. Power up the receiver again, holding down the SW2 delete button, then release the
button when both the DL9 LED and the BZ1 buzzer have gone off.
3. You must now wait until the deletion operation is completed (10 consecutive beeps).
When it is completed, the unit will run the memory test.
5.3 PROCEDURE FOR SELF-TEACHING OF THE FIRST REMOTE CONTROL
1. Power down the device.
2. Make sure that the memory is completely free (10 consecutive beeps); if not, delete the
memory (par. 5.2).
3. Press all the buttons on the first remote control you want to add at the same time (2
buttons for TR2 units, 4 buttons for TR4 units) until both the DL9 LED and the BZ1
buzzer come on (continuous beeping) to inform you that the self-teaching stage is
running.
4. Now press any key on the transmitter.
5. The DL9 LED and the BZ1 buzzer go off briefly briefly and then come back on,
confirming the self-teaching of the remote control within the memory of the receiver built
in the device.
5.4 PROCEDURE FOR SELF-TEACHING OF OTHER REMOTE CONTROLS
When the self-teaching of the first remote control is completed, while the signal is still ON,
you can add other remote controls by repeating steps 3 and 4.
Afterwards, you can start the remote control saving procedure again by pressing, at the
same time, all the buttons on a TX which has already been saved: the buzzer will sound and
you can now add extra remote controls by repeating steps 3 and 4.
INFORMATION:
• The procedure for self-teaching of the first remote control, as described above, is only
possible if the RX memory is completely empty.
• To quit the saving procedure, simply press the delete button.
• In any case, the system remains in self-teaching mode (continuous buzzer) for a
maximum of about 25 seconds before the receiver automatically returns to normal mode
(buzzer OFF).
• During the self-teaching procedure, the device outputs are disabled.
5.5 DELETING A REMOTE CONTROL
1. With the device powered up, hold down the delete button: the DL9 LED and the BZ1
buzzer come on (continuous buzzer).
2. Press any button on the remote control you want to delete.
3. The DL9 LED and the BZ1 buzzer will go off to indicate that deletion of the remote
control is complete.
• To delete more than one remote control, repeat stage 2 above, holding down the button.
• This procedure is useful for deleting remote controls which have been saved by
mistake. However, you can subsequently save the remote control deleted in the receiver
again, following the procedure described above.
Button
Power supply
Remote control
activation
Buzzer
Key
Power supply
Buzzer
Deletion command Memory free signalDeletion
phase

Aprimatic T22 Specifications

General

Brand	Aprimatic
Model	T22
Category	Control Systems
Language	English