APsystems DS3D - AC Bus Cable End Cap Installation

APsystems Microinverter DS3D User Manual
11
4.APsystems Microinverter System Installation
AC connector interface as from left to right.
Figure 6
Cover any unused connectors with Bus Cable Y-CONN to protect the unused connectors.
Figure 7
4.3.6 Step 6 - Install a Bus Cable End Cap at the end of AC bus cable
a. Strip cable jacket. c. Insert the wires into the cable clamps.
b. Insert the cable end into the seal. d. Rotate the nut with 3.3N·m until the
latching mechanism meets the base.
Figure 8
Nut
Seal
Body