ECU-C Installation/User Manual
3.Hardware Instrallation
Attach two buckles below in the edge of the guide, press two buckles
above, then embed to the edge of the guide.
Figure 7
Do not put the antennas inside a metal box, that will block the signal.
If the roof is metal, please use this long cable antenna, and place it outside
or on roof.
2) Using a Wall Mount
When mounting the ECU-C to a wall, make sure to select a cool, dry indoor
location.
According to the size of an icon, The energy communicator is fixed on the
wall with two Wall screws or wall anchors.
Four M4 screws + spacers are fixed to the wall, and the punch sizes are
as follows:
Figure 8
110mm(4.3' )'
129.4mm(5' )'
To Next Page
Loading...
