APsystems YC600 - Stpe 4 - Connect the Apsystems Microinverter to AC Bus Cable

Y
C600 Installation/User Manual
10
4.APsystems Microinverter System Installation
4.3.4 Stpe 4 - Connect the APsystems microinverter to AC bus cable
Push the microinverter AC connector onto the trunk cable connector. Listen for the "Click".
Figure 4
Best Practice: For removal use the Bus Cable Unlock Tool of AC Bus to split the connectors.
Figure 5
Check the Microinverter technical data page (p.18) for the maximum allowable number of
Microinverters on each AC branch circuit.
AC connector interface as follows.
Figure 6
Cover any unused connectors with Bus Cable T-CONN to protect the connectors.
Figure 7
L
PE
L
Click