Aputure Light Storm LS 600d - Setting Up the Light; Protection Cover Installation; Hyper-Reflector Installation

-6-
Setting Up the Light
Notice: Always remove the protection cover prior to turning on the light. Always re-install
the cover when packing it away.
1. Attaching/detaching the protection cover
Pull back the retaining pin, rotate the cover clockwise, then detach the cover.
To reattach the cover, insert it into the Bowens mount and rotate counterclockwise.
2. Attaching/detaching the Hyper-Reflector
To install the reflector, pull back the retaining pin, insert the reflector into the Bowens
mount, and rotate it counterclockwise as shown in the following pictures.
To remove the reflector, pull back the retaining pin and rotate the reflector clockwise.
5-Pin Female Head Cable Connector
DMX IN
Port
DMX OUT
Port
Neutrik®
powerCON
Power Input
48V DC Input
(3-Pin XLR)