Aqua Computer aquastream ULTIMATE - 14 Sensor Configuration; External Flow Sensor; Virtual Flow Sensor (Software Extension Virtual Flow Sensor Only); Offsets for Temperature Sensors

AQUASTREAM ULTIMATE
● Fan current too high: Fan output deactivated. Shut down PC immediately!
Shut down PC immediately!Shut down PC immediately!
Shut down PC immediately!
● Fan amp error: Fan output deactivated. Shut down PC immediately!
Shut down PC immediately!Shut down PC immediately!
Shut down PC immediately!
14.
14.14.
14. Sensor configuration
Sensor configurationSensor configuration
Sensor configuration
aquasuite: Select “Sensors” from the device list below the “aquastream ULTIMATE”
entry.
Device menu: Select “Sensors” from the menu list and confirm by pressing the
middle key.
14.1.
14.1.14.1.
14.1. External flow sensor
External flow sensorExternal flow sensor
External flow sensor
Calibration values for sensors sold by Aqua Computer can conveniently be select-
ed from a drop-down list. Select the appropriate entry for the flow sensor connect-
ed to the aquastream ULTIMATE.
If necessary, the flow rate can be calibrated by ±10 %.
14.2.
14.2.14.2.
14.2. Virtual flow sensor (software extension Virtual Flow Sensor only)
Virtual flow sensor (software extension Virtual Flow Sensor only)Virtual flow sensor (software extension Virtual Flow Sensor only)
Virtual flow sensor (software extension Virtual Flow Sensor only)
If the software extension “Virtual Flow Sensor” is activated, the aquastream ULTI-
MATE continuously calculated the current flow rate from a variety of pump param-
eters.
If necessary, the flow rate can be calibrated by ±10 %. Flow rates below 40 l/h
will not be displayed due to increasing imprecision of the calculation method for
low flow rates.
Limitations: Flow rate can not be calculated if a second pump is present in the
cooling circuit! Flow rate calculation is calibrated for DP Ultra viscosity and will
deviate when using other coolants ore pure water!
14.3.
14.3.14.3.
14.3. Offsets for temperature sensors
Offsets for temperature sensorsOffsets for temperature sensors
Offsets for temperature sensors
If necessary, each temperature sensor can be calibrated by adding an offset of
±15 °C.
14.4.
14.4.14.4.
14.4. Software temperature sensors
Software temperature sensorsSoftware temperature sensors
Software temperature sensors (Advanced Controller Package only)
(Advanced Controller Package only) (Advanced Controller Package only)
(Advanced Controller Package only)
Software temperature sensors can be used to transfer temperature sensor readings
to the aquastream ULTIMATE from the computer by USB connection or from an
aquaero 5/6 by aquabus connection. Two procedures are implemented:
1. Sensor data is transmitted from an aquaero 5/6 connected to the aquas-
tream ULTIMATE via aquabus.
2. During installation of the aquasuite, the background service “Aqua Comput-
er Service” is also installed. This service supplies various data from PC com-
ponents, additionally sensor data provided by third party software can be
accessed. In order to access third party software data, the third party soft-
ware has to be correctly installed, configured and running.
© 2016-2018 Aqua Computer GmbH & Co. KG - 21 -
Gelliehäuser Str. 1, 37130 Gleichen
c
o
m
p
u
t
e
r
a
q
u
a