Commissioning
06|2019 EN 21
5 Commissioning
NOTICE
The pump can be damaged if it runs dry!
Ensure that the pump is always full of water.
5.1 Checking how easily the pump rotates
After longer idle periods, the pump must be checked for how
easily it rotates while it is switched off.
Place a screwdriver in the groove on the end of the motor
shaft on the fan side and turn it.
5.2 Filling with water
System Filling with water
Below the
water level
Open the shut-off valve at the suction and
pressure side (not included in the scope
of delivery).
Do not install the filter system more than
3 m below the pool water level.
Above the
water level
Use self-priming pump.
See pump operating instructions
Fill the pump with water through the pre-
filter and screw the pump cover back on.
Ensure that the seal in the lid is not
damaged or twisted.
Do not install the filter system more than
2 m above the water level.
With
suspended
skimmer
Do not connect the suction hose to the
skimmer until it is completely filled with
water.
NOTICE
High cp.oncentrations of water treatment chemicals can damage
the filter system!
Do not place water treatment products, particularly in tablet
form, into the strainer basket of the pump or filter system.
To Next Page
Loading...
