Aqua HC151+ pH (RX) - User Manual

HC151+ pH(Rx)-Cl(J) / HC200+ pH(Rx)
ENGLISH
USE AND MAINTENANCE INSTRUCTIONS MANUAL
FOR DOSING PUMP
HC200
+
pH(Rx)

Summary

GENERAL RULES

INSTALLATION STANDARDS

Guidelines for safe and correct pump installation, including grounding and electrical safety.

OPERATION

OVERALL DIMENSIONS

Provides physical dimensions for HC151+ and HC200+ pump models with diagrams.

TECHNICAL FEATURES

Details power supply, insulation class, absorbed power, protection grade, and environmental conditions.

HYDRAULIC FEATURES

Presents flow rate, pressure, strokes, injection value, and absorbed power for different solenoid types.

PERFORMANCE GRAPHS

Graphs illustrating pump performance (pressure vs. flow rate) for different models (M60, M70, M80).

CONTENT OF THE PACKAGE (Standard version)

Lists the items included in the standard package for HC151+ or HC200+ pumps.

HC151+ pH(Rx)-CI(J); HC200+ pH(Rx)

HC151+;HC200+ PUMP CONTROLS

Describes the control panel components: graphic display, encoder knob, and stroke length adjustment.

HOW TO NAVIGATE THROUGH THE MENUS

Explains the user interface navigation, including accessing menus like Pump Setup, Settings, and Statistics.

FIRST PUMP INITIALIZATION

Guides the user through the initial setup process, including language, date, time, and measurement type selection.

GETTING STARTED

Covers initial operational steps like priming and calibration.

Priming

Instructions for priming the pump to fill the metering chamber and remove air bubbles before use.

Pump calibration

Detailed steps for calibrating the pump to determine the precise volume delivered per stroke.

PUMP SETUP

Allows programming the working point (setpoint) and proportional dosage based on measurement.

SETPOINT menu

Configures the operating point and intervention mode for the pump's dosage.

CALIBRATION menu

Guides the user through calibrating the pH, Redox, or Chlorine probes using buffer solutions or test kits.

CORRELATION BETWEEN FREE CHLORINE, pH e REDOX

Explains the correlation between free chlorine, pH, and Redox values, with an example for swimming pools.

SETTINGS

Provides access to general and security settings for pump configuration and operation.

General e Security

Details general settings (language, date, time) and security settings (password, alarms).

General > Proximity sensor

Explains how to enable/disable the proximity sensor for flow detection and its connection.

Generals > Temperature probe

Allows enabling the temperature sensor or manual setting for temperature compensation in measurements.

Generals > Measure startup delay

Sets a delay to allow probes to stabilize before the pump starts dosing, preventing incorrect data.

General > Energy saving

Adjusts display brightness to save energy and extend display life, with auto-dimming functionality.

Security > Password

Enables setting a password to prevent unauthorized access to pump configuration menus.

Security > Level Input Polarity

Allows inverting the polarity of the level probe connection between Normally Open (N.O.) and Normally Closed (N.C.).

Security > Low Level Delay

Delays pump stop after level sensor activation to ensure continuous dosage, especially with safety margin lances.

Security > Over Feed Alarm (OFA)

Interrupts pump operation if the setpoint is not reached within the set time, requiring intervention to resume.

Security > Factory Settings restore

Resets the pump to its original factory settings, deleting most stored data and statistics.

STATISTICS

Allows viewing operational data such as total strokes count and calibration history.

DOSING PUMPS INSTALLATION RULES

ELECTRICAL CONNECTIONS

HC151+ PlmA model pump

Details the electrical connections for the HC151+ PlmA pump, including probe and signal inputs.

TROUBLESHOOTING

PROBLEM - CAUSE - SOLUTION

Lists common problems, their potential causes, and recommended solutions for pump issues.

MAINTENANCE

WARRANTY

Aqua HC151+ pH (RX) Specifications

General

Brand	Aqua
Model	HC151+ pH (RX)
Category	Water Pump
Language	English