HC151+ pH(Rx)-Cl(J) / HC200+ pH(Rx)
ENGLISH
3.7.4 Generals > Measure startup delay
Some probes need to polarize before reading the values correctly. If the pump starts dosing during the
probe stabilization period, it risks dosing based on incorrect data.
This function allows you to set a time (in minutes or seconds), which allows the probe to stabilize
correctly, before the pump starts to dose.
Here are the steps to set up this feature:
3.7.5 General > Energy saving
It is possible to change the brightness of the display during its normal operation, this to limit current
absorption and to protect the display from overheating and therefore increase its life. The brightness
can be changed from 100% (maximum brightness) to 10% (minimum brightness); once the percentage
has been chosen, the display will drop its brightness after 1 minute, if you act on the encoder the
brightness will return to the maximum value until it is no longer touched for more than 1 minute.
Here are the steps to set up this feature:
To Next Page
Loading...
