Shower head systems installation instructions Page 7
Ensuring the hose washer is in the correct position; attach the hose to
the wall outlet.
20
Wall mounted fixed head
Cut the outlet pipe to the finished length (55mm – 150mm measured from the finished wall surface)
using a rotary type cutter. If a hacksaw is used, the pipe end must be carefully de-burred and
chamfered.
Slide the wall spacer down the projecting pipe flush with the finished wall surface.
1
This product must be installed by a competent person in accordance with the relevant Water Supply
Regulations.
In addition to the guide below, it is essential that the written instructions in the main product
installation instructions are read and understood, and that you have all the necessary components
(shown in the main product installation guide) before commencing installation.
The shower head and arm is supplied complete with a 2 year guarantee.
The shower arm and rail kit is supplied with universal fixings intended to secure it to a suitable wall.
Please follow the main product installation instructions to fit the shower controller and processor/
diverter units (depending on product purchased) prior to installing the shower head and rail kit.
!
!
!
!
To Next Page
Loading...
