Your
shower was
9:20
Goodbye
Push lever
to power o
39
water turns o
STARTING YOUR SHOWER
To activate the Q™ Controller, use the proximity sensor, or touch the power
symbol until the screen wakes up. Then, push and release the Q
TM
lever to
start the shower. The Get Ready screen will appear on the display. After a
moment the target temperature will flash until it is reached. It will then
display the thermostatically controlled temperature.
Switching on and o
To switch o Auto Save Shower go to Settings. (See page 18 for more information).
Please see page 13 for more information about Profiles.
ENDING YOUR SHOWER
Touch the power symbol for approximately 1 second , then push the
Q™ lever to confirm and end the shower.
SAVING YOUR SHOWER SETTINGS
When your shower ends,
you will be asked if you
want to save the shower.
If you ignore the question,
the Q
TM
controller will
turn o after 5 seconds.
If you select YES, your
Hello
Warming
39
Get
Ready
39
Push Lever
water turns on
OK
1
YES N
Save this
shower?
shower will be assigned to the lowest profile
number available in the My Q
TM
menu.
6
To Next Page
Loading...
Need help?
General
