Aqualisa QUARTZ CLASSIC - Controller Operation Modes; Single Outlet Controller; Dual Outlet (Divert) Controller

Whilst the shower is in use, if the 2nd outlet button is pressed, the 1st
outlet will automatically stop and the 2nd outlet will start. Depending
on system pipe runs, there may be a slight outlet temperature change
when switching between outlets.
Single Outlet Controller
1. Turn the temperature dial to the required setting.
2. Press the ‘Start/Stop’ button on the controller to turn the shower on.
3. The blue LED display will flash until the selected temperature has been reached.
When the LED display is constant, step into your shower and enjoy!
4. The temperature may be adjusted whilst in the shower.
5. Press the ‘Boost’ on the controller to increase the flow of the shower when
desired. To turn ‘Boost’ o, press the ‘Boost’ button again at any time.
N.B. The strength of the ‘Boost’ button will vary depending on the water system
pressure and the configuration of the pipework. For further information, see the
Important Information section in the Smart Installation Guide.
6. Press the ‘Start/Stop’ button on the controller to turn the shower o.
BOOSTTEMPERATURESTART/STOP
Adjust before
or during shower
Increase flow rate
during shower
As a safety feature, the Aqualisa SmartValve
TM
has a maximum run time
of 20 minutes. The flow can be stopped and started at anytime by
pressing the ‘Start/Stop’ button.
This can be enhanced by activating and using the free Aqualisa app.
See pages 3 and 12 for details.
Dual Outlet (divert) Controller
1. Turn the temperature dial to the required setting. The temperature can be adjusted
at anytime by turning the dial.
2. Press the desired outlet button on the controller to turn the shower on.
3. The blue LED display will flash until the selected temperature has been reached.
4. When the LED display is constant, your shower is ready to use.
5. Press the active button to turn the shower o.
CHANGE OUTLETTEMPERATURESTART/STOP
Adjust before
or during shower
Outlet can be switched
whilst showering
Choose either outlet
upon starting
As a safety feature, the Aqualisa SmartValve
TM
has a maximum
run time of 20 minutes. The flow can be stopped and started at
anytime by pressing the ‘Start/Stop’ button.
This can be enhanced by activating and using the free Aqualisa app.
See pages 3 and 12 for details.
4 5