Dual Outlet (divert)
Wired Remote
Single Outlet
1. Press the ‘Start/Stop’ button on the remote to turn
the shower on.
2. The blue LED display will flash until the selected
temperature has been reached. When the LED
display is constant, step into your shower and enjoy!
3. Press the ‘Start/Stop’ button on the remote or main
controller to turn the shower o.
1. Press the wired remote button to turn the shower on.
2. Water will flow from the primary outlet as determined
during the ‘Wired remote setup’ procedure.
3. If required, push and hold the button for 2 seconds
to stop the 1st outlet and start the 2nd outlet.
4. The blue LED display will flash until the selected
temperature has been reached.
5. When the LED display is constant, your shower is
ready to use.
6. Press the remote or active button on the controller to
turn the shower o.
Adjustable Head
To avoid water dripping from the shower head after use, we advise to tilt the head back
to allow residual water to drain out.
The above recommendation applies to both adjustable and fixed shower heads.
4. Eco3. Outer2. Middle1. Inner
4
3
1
2
8 9
To Next Page
Loading...
