Aqualisa SMART - Incorrect Outlet Flow in Divert Models; Flow Switching Between Outlets Not Working

Water flows
from incorrect
outlet (divert
models only)
Pipe work configured
incorrectly
Refer to section: Diverter Controller Matrix.
Primary outlet setting
not configured
Refer to section: Diverter Controller Matrix.
Outlets not
configured (For
models with display
screen only)
Refer to User Guide: Settings Section - Configuring
your Outlets.
Flow will
not switch
between outlets
Communications issue Check that 2m patch lead is connected between
Aqualisa SmartValve
TM
and diverter.
Ensure the correct 2m patch lead is connected -
refer to separate Components List.
Outlets not
configured (For
models with display
screen only)
Turn o the power supply to the Aqualisa
SmartValve
TM
, leave isolated for at least 2 minutes.
Reinstate power supply and then following instruction
in the User Guide (Settings Menu) complete a
factory reset, then proceed to Configure Outlets.
For further information and advice contact Aqualisa Customer Helpline.