EasyManua.ls Logo

Aqualisa Aquavalve 700 Series - User Manual

Aqualisa Aquavalve 700 Series
15 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Aqualvalve 700 Thermo installation instuctions page 1
Aquavalve 700
®
Thermo
shower valve

Table of Contents

Questions and Answers

  • N
    npageAug 4, 2025
    Why is the water not hot enough in my Aqualisa Plumbing Product?
    • U
      umullinsAug 4, 2025
      If the water from your Aqualisa Plumbing Product isn't hot enough, several factors could be the cause: * The temperature of the hot water cylinder might be too low. * The water flow through the hot water appliance might be too fast. * There may be an airlock in the hot water supply. To address this, ensure the pipe work is properly laid out, paying attention to potential air-traps. * The flow rate could be poor, leading to a low water temperature.
  • T
    Tasha DanielsAug 11, 2025
    What to do if Aqualisa Aquavalve 700 Plumbing Product water output is all hot or all cold?
    • C
      Carl CowanAug 11, 2025
      If your Aqualisa Plumbing Product is only outputting hot or cold water, or just cold water, it could be due to a couple of reasons: * The inlet supplies might be reversed. Check that the hot and cold water supplies correspond with the inlet markings on the product. * The cylinder temperature may not be sufficiently hotter than the blend temperature. The cylinder temperature should be at least 15°c hotter than the blend. Check the flow rate recommendations with the heater manufacturer.
  • N
    Natasha BooneAug 19, 2025
    Why does the water temperature swing between hot and cold in my Aqualisa Plumbing Product?
    • J
      John JohnsonAug 19, 2025
      If the water temperature from your Aqualisa Plumbing Product swings regularly between hot and cold, it could be due to high cold water pressure. If the static water pressure exceeds 7 bar, install a pressure reducing valve (PRV) in accordance with the installation guide.
  • K
    Katie ConradAug 27, 2025
    How to fix poor flow rate in Aqualisa Plumbing Product?
    • N
      Nicolas BarnettAug 27, 2025
      If you're experiencing a poor flow rate with your Aqualisa Plumbing Product, there might be a few reasons: * There could be debris in the shower head. Check for any obstructions and clear them out. * The filters might be clogged with debris. Inspect and clean them as needed. * Debris might be present in the cold inlet flow regulator. Check and clear any blockages. Also, ensure that the hose isn't twisted, which can restrict water flow.

Summary

Product Variants and Components

Aquavalve 700 Thermo Exposed Valve

Details of the Aquavalve 700 Thermo exposed shower valve model.

Aquavalve 700 Thermo Concealed Valve

Details of the Aquavalve 700 Thermo concealed shower valve model.

Exposed Valve Components

Visual guide to components included with the exposed valve installation.

Concealed Valve Components

Visual guide to components included with the concealed valve installation.

Important Installation Guidance

Introduction, Safety, and Preparation

Product overview, safety warnings, flushing, and connection advice.

System Requirements and Siting

Guidance on isolating valves, filters, and optimal product siting.

Water Supply and Pressure Guidelines

Requirements for pump, gravity, balanced, and combi systems, including pressure limits.

Installation Procedures

Exposed Valve Installation (Rear Entry)

Step-by-step guide for rear entry pipe work for exposed valve installation.

Exposed Valve Installation (Surface Sited)

Step-by-step guide for surface sited pipe work for exposed valve installation.

Concealed Valve Installation Steps

Step-by-step guide for installing the concealed Aquavalve 700 Thermo.

Post-Installation and User Guide

Reversed Supplies Adaptation

Procedure for adapting the valve for reversed hot and cold water supplies.

Commissioning and Temperature Setting

Instructions for setting maximum and minimum temperature adjustments.

Shower Operation and Cleaning

How to operate the shower valve and recommended cleaning methods.

Troubleshooting Common Issues

Guide to diagnosing and resolving common problems with the shower valve.

Typical Installation Diagrams

Gravity System Installation

Diagram illustrating a typical gravity fed shower system setup.

Pumped System Installation

Diagram illustrating a typical pumped shower system setup.

Thermal Storage Unit System

Diagram illustrating a typical thermal storage unit system setup.

UHW System Installation

Diagram illustrating a typical UHW (Unvented Hot Water) system setup.

Combination Boiler System

Diagram illustrating a typical combination boiler shower system setup.

Aqualisa Aquavalve 700 Series Specifications

General IconGeneral
BrandAqualisa
ModelAquavalve 700 Series
CategoryPlumbing Product
LanguageEnglish

Related product manuals