Universal shower kits installation guide page 3
Important information
Introduction
The Aqualisa range of shower heads has been designed for use with the Aqualisa Thermo and Digital shower valves.
The installation of this shower head with anything other than an Aqualisa shower valve may result in poor shower performance.
If you have any questions at any stage during installation please contact the Aqualisa customer helpline on 01959 560010.
Safety information
This product must be installed by a competent person in accordance with all relevant current Water Supply Regulations.
Flushing
Some modern fluxes can be extremely corrosive and, if left in contact, will attack the working parts of this unit. All soldering
must be completed and the pipe work thoroughly flushed out in accordance with current Water Supply Regulations prior to
connection of the product.
Connections
The Aqualisa shower head range is suitable for use with 15mm British Standard copper tube. Tube should be cut using a rotary
type cutter and lubricated using a silicone-based lubricant or petroleum jelly (Vaseline or similar) prior to insertion of the
fitting. Supply lines must be flushed clear of any debris before installation.
Stored water capacities
The minimum capacity of the cold storage cistern should not be less than 225 litres (50 gallons). The capacity of the hot
cylinder must be capable of meeting the anticipated demand.
Siting
For optimum performance, with gravity fed systems, the distance between the bottom of the storage cistern and the shower
head should not be less than 1m (when using an adjustable height shower kit). If using a fixed head, the highest point of the
pipe work must be below the underside of the cistern.
To Next Page
Loading...
