6.2.5 Local On/Off
When Local is turned on the stereo seeks to only the radio channels with strong signal strength.
When Local is turned off the stereo will seek to all radio channels it receives signal from.
When Local setting is turned on the word ‘Local’ will appear in the upper right hand corner of the stereo’s display.
6.2.6 Stereo/Mono
Change the output mode between stereo and mono.
6.2.4 Area USA/Euro
Select USA or European AM/FM radio frequencies.
USA mode will increase and decrease the FM frequency in steps of 0.1 MHz, e.g. 88.5, 88.6,88.7 MHz. EURO mode
will increase and decrease the FM frequency in steps of 0.05 MHz, e.g. 88.25, 88.30, 88.35 MHz.
6.2.3 Power On Volume (P-VOLUME)
Sets the maximum volume the stereo will be set when powering the unit on. If the stereo is
switched off with a lower volume than the P-Vol setting then the lower volume setting will be
used.
Normal volume control and operation is resumed once the Rotary Selector is turned after
switching the stereo on.
7.1 Listening to Auxiliary Devices
1. Connect your audio device to the rear RCA connectors using a stereo RCA cable.
2. Press MODE on the stereo to select ‘AUX IN’ mode.
3. Play the song from your auxiliary audio device and the sound will play through the stereo.
4. Volume level will be determined by the auxiliary device’s audio output level.
Always ensure you connect and disconnect the stereo with dry hands!
7.2 Dimmer High/Low
Adjust the display brightness from 100% for normal operation to 30% brightness to reduce
screen glare during night time operation.
Additional Features
Settings Operation GP1 WATERPROOF STEREO
12www.aquaticav.com
To Next Page
Loading...