AR 25A250B - Remote Command Queries; Identity Query; IO Board Firmware Revision

Model 25A250B
14 Rev A
2.4.6.4 Identity
Query to identify the amplifier:
Syntax: *IDN?
Parameters: None
Query only (always requires a ? character)
Response Format: f,m,n,<LF>
Where:
f = manufacturer
m = model designation
n = firmware revision
Example: To get the identity of the amplifier, send the following command: *IDN?<LF>
Response: AR-RF/MICROWAVE-INST,25A250B,1.0<LF>
2.4.6.5 IO Board Firmware Revision
Query to get the firmware revision of the IO Board.
Syntax: *IOB?
Parameters: None
Query only (always requires a ? character)
Response Format: INTERFACE_BOARD_SW_REVx<LF>
Where:
x = firmware revision
Example: To get the firmware rev. of the IO Board, send the following command: *IOB?<LF>
Response: INTERFACE_BOARD_SW_REV2.01<LF>