Last Rev Date: 13/12/2022
Fitting instructions# 37801222
Copyright © 2022 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
ARB 4x4 ACCESSORIES
Corporate Head Office
42-44 Garden St Tel: +61 (3) 9761 6622
Kilsyth, Victoria Fax: +61 (3) 9761 6807
AUSTRALIA 3137
Australian enquiries sales@arb.com.au
North & South American enquiries sales@arbusa.com
Other international enquiries exports@arb.com.au
www.arb.com.au
GENERAL CARE AND
MAINTENANCE
By choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products
in the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent
value. To keep your bar in original condition it is important to care and maintain it following these
recommendations:
▪ Prior to exposure to the weather your bar should be treated to a Carnauba based polish on all
exposed surfaces. It is recommended that this is performed on a six-monthly basis or following
exposure to salt, mud, sand or other contaminants.
▪ As part of any pre-trip preparation, or on an annual basis, it is recommended that a thorough visual
inspection of the bar is carried out, making sure that all bolts and other components are torqued to
the correct specification. Also check that all wiring sheaths, connectors, and fittings are free of
damage. Replace any components as necessary. This service can be performed by your local
authorized ARB Stockist.
REQUIRED TOOLS FOR FITMENT OF PRODUCT:
METRIC RING AND OPEN ENDED SPANNER SET
ELECTRIC DRILL 13MM CAPACITY
SMALL EXT CIR CLIP PLIERS
PHILLIPS AND FLAT HEAD SCREWDRIVER SET
TAPE MEASURE OR STEEL RULER
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a
potentially hazardous situation it is suggested that protective safety gear be worn or a safe work
procedure be employed. If these notes and warnings are not heeded, injury may result.
To Next Page
Loading...
