ARB AC08C - Page 2

15-02-2019 Page 2 of 44 ARB Copyright 2019 3789507
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT:
Protective eyewear
Hearing protection
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a potentially
hazardous situation it is suggested that protective safety gear be worn or a safe work procedure be
employed. If these notes and warnings are not heeded, injury may result.
TOOL LIST FOR FITMENT:
 Torque Wrench 0-25Nm
 Sockets ¼”, 10 & 13mm, hex Allen key
sockets, socket extension bar and driver
 Spanners, ratchet type, 8, 10 and 13mm.
 Tape measure
 150mm ruler
 Power or pneumatic drill
 Drill bits 6.5mm, 5.2mm.
 10 and 12mm drill stops
 12mm deep drill stops for 6.5 and 5.2mm
drill bits.
 Knife
 Sharp scissors
 File or sheet metal de-burring tool
 Metal primer touch up paint
 Engineer’s scribe
 Sheet metal vice grip clamp
 Quicklock G clamp
 Centre punch
 Silicon Caulking Gun
 Neutral cure Non Acetic Silicon
 Phillips head screwdrivers
 Flat blade screwdrivers
 Side Cutters
 Non-permanent marker
 Electrical tape
 Masking tape
 Plastic Squeegee
 Cleaning cloths / rags
 Angle grinder and grinding and cut off
wheels
 Sheet of plywood A3 in size.
 Cable ties 2 off 200mm long (not supplied)
 Cable ties 3 off 450mm long (not supplied)
FITTING THE CANOPY IS UNDERTAKEN IN THE FOLLOWING STAGES:
1. Removing any sports bars, cabin guards and bed liners.
2. Fitting the tub mounting brackets. (Note details of fitting with bed liners refer to
Section 6)
3. Fitting vehicle wiring.
4. Fitting the canopy to the vehicle
5. Operational checks and adjustment options for doors and windows.
6. Fitting the tub mounting brackets with bed liners.
7. Recording of key code and owner’s manual supplement.
8. Check list and sign off.
NOTE: DURING THE INSTALLATION IT IS NECESSARY TO DRILL SOME HOLES THROUGH THE
VEHICLE’S TUB SHEET METAL. IT IS RECOMMENDED THAT THESE ARE DE-BURRED
AND THE RUST INHIBITOR THAT IS PROVIDED BE USED TO AVOID RUST & ANY
SWARF LEFT OVER SHOULD BE CLEANED FROM THE TUB.