15-02-2019 Page 16 of 44 ARB Copyright 2019 3789507
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
2.26) Drill 5.2mm holes through the exiting holes in
lower part of the rear bracket with a 12mm
deep drill stop fitted to avoid drilling too far.
Remove any swarf. Apply rust inhibitor (665505)
to the drilled holes and assemble two rivets
(6609087).
2.27) If an ARB bed liner or Sport Guard is now to be
fitted refer to Section 6. For an OEM bed liner do
this after measuring off bracket positions on the
tub and measuring these out on the bed liner and
cut away sections of the bed liner to suit the
canopy mounting brackets.
SECTION 3: FITTING THE VEHICLE WIRING
The diagram below offers a reference to assist the routing of wires
To Next Page
Loading...
