ARC Flex ECO Series - Receiver; Receiver 4.2.1 Receiver Channel Setting

Flex ECO 6S/X MRX Instruction Manual
August 2017 v1.0
Page 18 of 34
71 423 56 8
1 2 3 4 5 6 7 8
ON DIP
ON DIP
S3 DIP 1~6
Function
Number
Display Type PB1 PB2 PB3 PB4 PB5 PB6
5
5 Reds Normal Normal Normal Normal LED A Normal
6
6 Reds Normal Normal Normal Normal Normal LED B
13
1 Green + 3 Reds LED A LED B Normal Normal Normal Normal
14
1 Green + 4 Reds Normal Normal LED A LED B Normal Normal
15
1 Green + 5 Reds Normal Normal Normal Normal LED A LED B
* PB1…PB6 → Pushbutton number.
* Normal → Normal momentary contact.
* LED A & LED B → Pushbutton toggled function with designated LED indication.
4.2 Receiver
4.2.1 Receiver Channel Settings
Set the receiver channel by configuring the S3 channel dipswitch located on the RF/decoder
board, only the first 6 dip positions are used for channel programming. The system channels
table on section 4.2.6 illustrates which dipswitch setting corresponds to which channel. Once
the receiver channel is altered do make sure to change the transmitter channel as well. The
channel on both transmitter and receiver must be identical in order for the system to work
(refer to section 4.1.2 Transmitter Channel Settings).
Example:
Top position → “1”
Bottom position → “0”
The above dipswitch setting “1 0 0 1 0 0” corresponds to “channel 36” in the system channels table
on section 4.2.6.
4.2.2 Output Relay Configurations
4.2.2.1 Output Relay Types
1. 2 output relays per motion – single speed only
Output relays with Forward (F) and Reverse (R) 1
st
speed only.