EasyManua.ls Logo

ARCAIR N6000 Automatic System - User Manual

Default Icon
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Issue Date: October 1, 2007
Manual No: 89210000
Safety and Operating
Instructions
N6000
Automatic
System
English
Français
Español

Table of Contents

Questions and Answers

  • A
    Alec HannaAug 28, 2025
    Why does the ammeter not register on my ARCAIR Industrial Electrical?
    • J
      Jonathan RodriguezAug 28, 2025
      If your ARCAIR Industrial Electrical system's ammeter isn't registering, there might be a break in the interconnect cable linking the contactor to the controller; repair or replace the cable. Check for loose connections on the shunt on the contactor unit and repair them. Also, ensure the connectors J4/J5/J6 are firmly connected on the MCCB. If these steps don't resolve the issue, the ammeter itself might be defective and need replacement.
  • L
    Lisa CooperAug 27, 2025
    What causes the tractor to not run in auto mode on my ARCAIR N6000 Automatic System Industrial Electrical?
    • J
      Jonathan SmithAug 27, 2025
      If the ARCAIR Industrial Electrical tractor won't run in auto mode, check for voltage at the receptacle and repair if needed. Also, check if the breaker on the tractor has tripped and reset it if necessary. If the issue persists, the power switch, motor, motor speed control, or transformer might be defective and need replacement.
  • L
    Lori CarsonAug 27, 2025
    Why is the contactor overheating on my ARCAIR N6000 Automatic System?
    • K
      Kayla TorresAug 27, 2025
      If your ARCAIR Industrial Electrical system's contactor is overheating and the overheat indicators are on, the filter might be clogged. Clean the filter thoroughly, replacing it if necessary. Also, check the fan operation; if it's not operating or not operating efficiently, replace it.
  • A
    Adam McdowellAug 25, 2025
    Why will the tractor not run with the switch in the 'ON' position on my ARCAIR N6000 Automatic System?
    • L
      Lisa JosephAug 26, 2025
      If the ARCAIR Industrial Electrical tractor won't run with the switch in the 'ON' position, verify that the engagement lever is engaged. Also, check for power continuity from the source to the tractor. Look for a tripped breaker on the tractor and reset it if necessary. Inspect the power cable for any breaks and repair or replace it. If these steps don't resolve the issue, the power switch or the motor itself might be defective, requiring replacement. Also consider checking the motor speed control and transformer.
  • T
    Timothy SmithAug 25, 2025
    What to do if the electrode will not feed or retract on my ARCAIR N6000 Automatic System?
    • E
      Edwin WagnerAug 25, 2025
      Several factors can prevent the electrode from feeding or retracting on your ARCAIR Industrial Electrical equipment. First, ensure the electrode is correctly inserted and makes optimal contact with the drive system. If the contact shoe surface is damaged due to arcing, repair it by sanding if the damage is minor; otherwise, replace the shoe. Other potential issues include a defective “Jog” switch or “Control Power” switch on the control panel, a faulty motor cable connection on the MCCB*, a defective MCCB*, or a defective electrode drive motor. Replace any defective components.

ARCAIR N6000 Automatic System Specifications

General IconGeneral
BrandARCAIR
ModelN6000 Automatic System
CategoryIndustrial Electrical
LanguageEnglish